Intec FORCE/2 HP Instruction Manual page 15

Problem
Agitator does not run.
Machine is on, yet no material
comes out of hose.
Insulation exiting hose is
dribbling out.
Circuit breakers need resetting
often.
T: 303-833-6644
Original Language - English
Blower has to be on for agitator
to come on.
Agitator circuit breaker needs to
be pressed.
Foreign material causing jam in
hopper.
Agitator motor windings have
overheated.
Slide gate is closed.
Insulation blockage in hose.
Air pocket in hopper is
preventing insulation from
feeding into agitators.
Airlock seal is worn.
Airlock has an obstruction
preventing insulation from
exiting.
Heavy insulation material.
Kink in hose.
Airlock seal is worn.
Low voltage or low amperage.
Extension cord gauge is too
small.
800-666-1611
or
Likely Cause
Instruction Manual
Remedy
Turn blower on.
Ensure agitator circuit breaker is
reset.
Remove power cords, clear jam,
and restart system.
Let system cool. If happens
often, contact Intec for settings.
Open slide gate.
Turn system off, remove hose
and clear blockage.
Disconnect electrical power.
Redistribute insulation material
inside hopper.
Inspect airlock seals for cuts and
wear. Have a qualified
technician replace airlock seals.
Disconnect electrical power,
remove obstruction.
Push slide gate in 1-2 holes.
Straighten hose.
Inspect airlock seals for cuts and
wear. Have a qualified
technician replace airlock seals.
System requires 115V / 15amp
separate circuits for agitator and
blower.
Use a 12/3 heavy duty (i.e.
SJ300V) extension cord when
length is 100' or less. Use a 10/3
heavy duty extension cord when
length is over 100'.
www.inteccorp.com
| 14