Required Tools - HP 3000/9x9KS Series Upgrade Manual

HP 3000/9x9KS and HP 9000/K2x0/K4x0/Kx70/Kx80 Memory Upgrade Installation
Introduction
Electrostatic Discharge (ESD) Precautions. When performing the upgrade procedures in this guide,
you must observe the following antistatic precautions to prevent damage to memory boards and system
components from electrostatic discharge. An ESD kit (HP P/N A3024-80004) is supplied with your
memory upgrade kit. This ESD kit contains one wrist strap, one conductive sheet, and one anti-static
foam pad.
• Always wear a grounded wrist strap when working on or around the system, and when handling
printed circuit boards.
• Treat all assemblies, components, and interface connections as static-sensitive.
• Perform all removal and installation in a work area where potential static sources are minimized
(preferably an anti-static work station).
• Avoid working in carpeted areas, and keep body movement to a minimum while removing and
installing boards to minimize buildup of static charge.

Required Tools

• One #10 Torx driver (preferred tool)
• One small flat-blade screwdriver (if Torx driver is not available)
1-2 Chapter 1