Table of Contents
Advertisement
Third Party Racking Option for VMAX 250F
Site Planning Guide VMAX 250F, VMAX 450F, VMAX 850F, VMAX 950F with HYPERMAX OS
92
EMC provides a
power and weight
and heat values to more-closely match the hardware configuration for your system.
Engine and 2U SPS power requirements
Table 25 Engine and 2U SPS power requirements
Requirement
AC line voltage
AC line current (operating maximum)
Power consumption (operating maximum)
Heat dissipation (operating maximum)
In-rush current
AC protection
AC inlet type
Charge times
Notes:
Ratings assume a fully loaded engine. Product power may vary depending on each product
l
configuration. For specific product configuration power numbers, refer to the EMC power
calculator, https://powercalculator.emc.com. The power calculator only supports
products with an input voltage of 200-240 V AC.
All power figures shown represent max normal operating numbers with the chassis running
l
in a normal 20ºC to 25ºC ambient temperature environment. The chassis power numbers
given may increase 5% when running in a higher ambient temperature environment.
calculator. Use this calculator to refine the power
Description
200 to 240 V AC ± 10%, single-phase, 47 to
63 Hz
6.38 A max, at 200V AC
1275VA (1250W) max, at 200V AC
6
4.5 x 10
J/hr. (4,265 Btu/hr.) max @ 200Vac
30 A max for ½ line cycle, per line cord at 240
V AC
10 A fuse on each power supply, one phase
IEC320-C14 appliance coupler, per power
zone
SPS will reach 95% capacity within 6 hours if
it is fully discharged.
Advertisement
Table of Contents
