Zone Run Times - Weathermatic SmartLine SL800 Owner's Manual

3.0 Programming for Standard Watering Mode
previous operation is completed, beginning with start time 1 in
Program A. If a concurrent program in D is running at the same
time as a program in A, B or C, the display will alternately
show the icon for both programs in the display.

3.3 Zone Run Times

Your SmartLine ® controller
will display remaining hours,
minutes and seconds when a
zone is watering. However,
in this position you are only
required to set minutes (or
hours and minutes) for each zone as desired for operation time.
Seconds are not selectable.
Use NEXT and BACK buttons to select zone for run time set-
ting. All zones are selectable from 1 minute to 9 hours and 55
minutes. Run times of OFF to 59 minutes are selectable in one
minute increments. Run times of 1 hour to 9 hours 55 minutes
are selectable in 5-minute
increments. Use ▲ or ▼
arrow buttons to set flashing
time values for each zone.
If a zone is not to be used,
set it to OFF. A zone with an
OFF setting is OFF in both
Standard and Auto Adjust
modes.
Push PGM button to assign
zone time in one or more
programs. Note: Program D
Note: If dis-
play shows "0
ZONES," this
indicates no
SLM4 modules are cur-
rently installed or have
ever been installed under
AC power with the control
panel firmly closed.
is for concurrent operation for
micro irrigation zones. Zones
assigned to Program D cannot
be assigned to Program A, B,
or C. Display will say USED
if attempt is made to enter
time in A, B, or C for a zone
already assigned operating
time in D.
Caution: If an unused zone
is turned on and activates a
pump start relay, the pump
may overheat or cause a
pipe to burst. To prevent
operating a pump with no
flow (dead heading), make
sure all unused zones are set
to OFF.
All zones to be utilized must be assigned a run time whether
you are using the Standard or Auto Adjust Mode. Your
SmartLine ® controller will use Zone Run Times as the backup
program for Auto Adjust. They will also be used as the run
times for the Run Manual Program Function.
7
Note: If you are
using an SLW
weather station
for Auto Adjust
watering, the controller
will not use the zone run
times that you set (See
4.0). However, you must
enter zone run times for
all zones in use. The run
times you enter are used
as backup in the event of
communication loss with
your SLW. They are also
used for the Run Manual
Program function.