Clearing Watering Programs; Clear One Program; Clear All Programs; Running Your Controller - Weathermatic SoloRain 8014 Series Owner's Manual

3.4.3 Clearing Watering Programs

3.4.3.1 Clear One Program

To clear the programming in one of the six programs, turn the
SELECT dial to PROGRAM 1, 2, 3, 4, 5, or 6 and rotate the SET
dial to CLEAR and press the key.

3.4.3.2 Clear All Programs

To clear all programming, turn the SELECT dial to the RUN
ALL position and the SET dial to the CLEAR position and
press both keys at the same time. This will clear all programs.
3.5

Running Your Controller

3.5.1

Run Your Scheduled Watering Program

You can choose to run all six programs or select any one of the
six. Turn the SELECT dial to your choice of RUN ALL to run all
the programs that have been entered or select the individual
PROGRAM number 1-6 that you wish to run. Turn the SET dial
to the RUN position. The 8014 will water per the program or
programs that you have selected.
3.5.2 Manually Running Your Controller
To turn the water on manually, turn the SET dial to the MANUAL
OPEN position. The LCD display will flash 10 minutes of run time.
There is a 30-second delay to open or close the valve. You can
adjust the desired run time from 1 minute to 6 hours by using the
keys, at any time during the manual run.

4.0 Advanced Features

To return to automatic operation turn the SET dial to RUN after the
manual run has started. The manual operation that you selected
will finish and the timer will return to automatic operation as
scheduled.
To stop manual watering rotate SET dial to the OFF position. Note:
The 8014SR will override the sensor if activated and run manually.

3.6 Turning the Controller Off

To discontinue watering when the timer is in operation or to
prevent automatic operation turn SET dial to the OFF position. To
return to automatic operation return SET dial to the RUN position.
4.0 Advanced Features

4.1 Setting a Rain Delay

To postpone programs due to wet weather turn the SET dial to the
RAIN DELAY position and adjust the desired delay from 1 to 99
days using the keys. Return the SET dial to the RUN position. The
RAIN DELAY symbol will show on the LCD. After the RAIN DELAY
the 8014 will return to automatic operation.

4.2 Operation with a Sensor Installed (8014SR only)

If a sensor has suspended watering, the RAIN DELAY symbol will
appear on the LCD. The symbol will turn off when the sensor has
dried out. The 8014SR will resume automatic operation at the
next start time. Rain sensor status is checked every 16 minutes
4
http://support.weathermatic.com