Program Start Times; Zone Run Times - Weathermatic smartline SL800 Owner's Manual

6

3.3 Program Start Times

Set Start Time for each
program to be used (A, B, C
and D). If more than three
program start times are
desired, refer to NUM STRT,
in Advanced Menu. The
program will start at the time
you designate and will water
all zones with set Zone Run
Times for that program.
For most watering programs set only Start Time #1. The #1
Time will water all zones with Zone Run Times set in that
program in consecutive order. Extra start times will re-run
all zones. Extra start times may be used for new planting
grow-in or other special local conditions. Unused start
times must be set in the OFF position. To set a start time at
OFF, press on either arrow button until you reach the OFF
postion located at midnight.
When setting program start times, check the program icon
in the display to see whether you are working in A, B, C or D.
Use PGM button to move between programs. Use NEXT and
BACK buttons to move between start times. Use UP and DOWN
buttons to set each start time desired. Start times are selectable
in 10-minute increments.
Note: Be sure you select the AM/PM time as desired by
scrolling past 12. (For international users, the display will show
international hours instead of AM/PM.)
If a run time overlaps the next program start time, the
SmartLine® controller will stack the start times within each
program and between programs, beginning those operations
http://support.weathermatic.com
at the time the previous operation is completed, beginning with
start time 1 in Program A. If a concurrent program in D is running
at the same time as a program in A, B or C, the display will
alternately show the icon for both programs in the display.
PROGRAM START TIMES

3.4 Zone Run Times

Your SmartLine® controller
will display remaining hours,
minutes and seconds when
a zone is watering. However,
in this position you are only
required to set minutes (or
hours and minutes) for each
zone as desired for operation
time. Seconds are not
selectable.
Use NEXT and BACK buttons
to select zone for run
time setting. All zones are
selectable from 1 minute to
9 hours and 55 minutes. Run
times of OFF to 59 minutes
are selectable in one minute
increments. Run times of 1
hour to 9 hours 55 minutes
are selectable in 5-minute
increments. Use UP or DOWN
buttons to set flashing time
values for each zone. If a
zone is not to be used, set it
to OFF.
Programming 3.0
ZONE RUN TIMES
Note: Run/Soak
feature can
reduce the need
to set multiple
start times for the purpose
of preventing runoff. Using
the combination of multiple
start times and Run/Soak
cycles can lead to extended
watering windows since Run/
Soak cycles are applied to
each start time. See Soil Type,
Page 11.