Using The Cutting-Unit Kickstand; Applying The Ce Decals - Toro Reelmaster 5010-H Operator's Manual

4. Outside the hood, insert the hook end of the
latch through the hole in the hood. Make sure
that the rubber sealing washer remains on the
outside of the hood.
5. Inside the hood, insert the metal washer onto
the latch and secure with the nut. Make sure
that the latch engages the frame catch when it
is locked. Use the enclosed hood-latch key to
operate the hood latch.
7
Using the Cutting-Unit
Kickstand
Parts needed for this procedure:
1 Cutting-unit kickstand
Procedure
Whenever you need to tip the cutting unit to expose
the bedknife/reel, prop up the rear of the cutting unit
with the kickstand to make sure that the nuts on the
back end of the bedbar-adjusting screws are not
resting on the work surface
1. Cutting-unit kickstand
Secure the kickstand to the chain bracket with the
snapper pin (Figure 21).
(Figure 20).
Figure 20
1. Chain bracket
2. Snapper pin
8

Applying the CE Decals

Parts needed for this procedure:
1 Warning decal
1 CE decal
1 Production year decal
Procedure
On machines requiring CE compliance, apply the
production year decal (Part No. 133-5615) near the
serial plate, the CE decal (Part No. 93-7252) near
the hood lock, and the CE warning decal (Part No.
133-2931) over the standard warning decal (Part No.
133-2930).
g003985
16
Figure 21
3. Cutting-unit kickstand
g004144