Starting The Engine; Shutting Off The Engine - Toro Reelmaster 5010-H Operator's Manual

Starting the Engine

Important:
You must bleed the fuel system before
starting the engine if you are starting the engine
for the first time, the engine has shut off due to
lack of fuel, or you have performed maintenance
on the fuel system; refer to
System (page 26).
1. Sit on the seat, keep your foot off the traction
pedal so that it is in N
brake, set the engine-speed switch to the F
position, and ensure that the Enable/Disable
switch is in the D
2. Turn the key to the O
An automatic timer controls the glow plug
preheat for 6 seconds.
3. After preheating the glow plugs, turn the key to
the S position.
TART
Crank the engine for no longer than 15 seconds.
Release the key when the engine starts. If
additional preheating is required, turn the key to
the O position and then to the O
FF
position. Repeat this process as required.
4. Run the engine at low idle speed until it warms
up.

Shutting Off the Engine

1. Move all controls to N
parking brake, move the throttle to the L
position and allow the engine to reach low idle
speed.
Important:
Allow the engine to idle for 5
minutes before shutting it off after a full
load operation. Failure to do so may lead to
trouble on a turbo-charged engine.
2. Turn the key to the O
from the switch.
Bleeding the Fuel
, engage the parking
EUTRAL
position.
ISABLE
/P position.
N REHEAT
/P
N REHEAT
, engage the
EUTRAL
position and remove it
FF
AST
OW IDLE
28