Safety Instructions For Installation - Miele CS 1411 Operating And Installation Instructions

Safety instructions for installation

Fit the wall units and cooker hood before fitting the CombiSet to avoid dam-
aging it.

The veneer or laminate coatings of worktops (or adjacent kitchen
units) must be treated with 100 °C heat-resistant adhesive which will
not dissolve or distort. Any backmoulds must be of heat-resistant
material.

A deep fat fryer must not be installed directly next to a gas hob or
a wok burner as the gas flames could ignite the fat in the fryer. It is
essential to maintain a distance of at least 288 mm between these
two appliances.

When installing the CombiSet, make sure that the connection
cable cannot come into contact with hot appliance parts.

The electrical cable of the CombiSet must not come into contact
with any moving kitchen component (e.g. a drawer) or be subject to
any mechanical action which could damage it.

Observe carefully the safety clearances listed on the following
pages.
All dimensions are given in mm.
30