Important Installation Safety Instructions - Miele CS 1411 Operating And Installation Instructions

IMPORTANT INSTALLATION SAFETY INSTRUCTIONS

Note to the installer:
Please leave this instruction book
with the consumer for the local
electrical inspector's use.
The minimum distances given in
these Installation Instructions must
be observed in order to ensure safe
operation. Failure to do so increases
the risk of fire.
The cabinetry and venting hood
should be installed first to prevent
damage to the appliance.
~
Deep fryers must not be installed
next to gas cooktops. Gas flames can
ignite splattering oil. A distance of at
5
least 11 / " (288 mm) should be
16
maintained between these two
appliances.
~
The countertop must be bonded
with heat resistant (212°F/100°C)
adhesive to prevent distortion or
dissolving.
Any back splashes should be
heat-resistant as well.
~
To eliminate the risk of burns or fire
by reaching over heated surfaces
cabinet storage space above the
appliance should be avoided. If cabinet
storage is necessary, the risk can be
reduced by installing a venting hood to
project horizontally a minimum of 5"
(127 mm) beyond the bottom of the
cabinets.
22
~
The appliance must not be
permanently sealed into the countertop
when installed. The sealing strip under
the edge of the appliance provides a
sufficient seal for the countertop. See
"Sealing".
~
You must ensure the power cord for
the appliance will not come in contact
with any mechanical parts after
installation, e.g. while draining the
appliance.
~
This appliance must not be used in
a non-stationary location (e.g. on a
ship).
Keep this instruction book in a safe
place and pass it on to any future
owner.