Miele CS 1411 Operating And Installation Instructions page 40

Installation
Installing the CombiSet
 Feed the mains connection cable
down through the cut-out.
 Starting at the front, position the
CombiSet in the worktop cut-out.
 Using both hands, press down evenly
on the edges of the CombiSet until it
clicks into position. When doing this
make sure that the seal underneath
the appliance sits flush with the work-
top. This is important to ensure an ef-
fective seal with the worktop.
Do not use sealant (e.g. silicone).
If the seal does not meet the worktop
correctly on the corners, the corner ra-
dius (≤ R4) can be carefully scribed to
suit.
40
Building in several CombiSets
 Push the built-in CombiSet to the
side until the holes in the spacer bar
can be seen.
 Fit cover strip  into the holes in
spacer bar .
 Starting at the front, position the next
CombiSet in the worktop cut-out.
 Proceed as described previously.