Table of Contents
Advertisement
WARNING
Risk of explosion when working with solvents
Ensure adequate ventilation.
Do not smoke!
WARNING
Risk of eye injury
Rotating parts can throw off small foreign particles such as sand or dust.
Wear protective eyewear!
In addition to the prescribed personal protection gear, also wear suitable protective gloves and safety glasses.
2
Agitator flange
For helical gearbox DR/ZR sizes 68 to 168
2.1
Technical description
①
Bearing in oil bath
②
Greased bearing
Figure 2-1
Bearing in agitator flange
The multistage helical gearbox can be supplied with an upstream agitator flange.
With an upstream locating bearing, the bearing system is suitable for high external forces. The absorbed radial and axial
loads are transmitted to the machine via the agitator flange.
The bearings in the agitator flange are lubricated independently of their design. The output-side bearing is greased. Initial
greasing has already been carried out. The opposing bearing runs in a gearbox-oil bath.
The agitator flange can be optionally supplied with an automatic regreasing device, see Regreasing intervals (Page 6). In
this case, the output-side bearing is not sealed with NILOS rings or caps.
BA 2510
A5E38121849A/RS-AB, 10/2016
5
Advertisement
Table of Contents
