Denon DN-V1700 Service Manual page 21

Pin No. Name
120 Receive Clock
123-126 Receive Data
Management Data
27
Input
Management Data
28
Output
29 Management Clock
128 Receive Error
nChip Select
4
Output
14 External Resistor
16
17
19
20
24
25
Note (1) - If the EEPROM is enabled.
Buffer
Symbol
Type
I with Input. Receive clock input from MII. Nibble rate clock. (25MHz for 100Mbps &
RX25
pullup 2.5MHz for 10Mbps).
RXD0- I with
Inputs. Received Data nibble from MII PHY.
RXD3 pullup
I with
MDI MII management data input.
pulldown
MDO O4 MII management data output.
MCLK O4 MII management clock
Input. Indicates a code error detected by PHY. Used by the LAN91C111 to
I with
RX_ER discard the packet being received. The error indication reported for this event is
pulldown
the same as a bad CRC (Receive Status Word bit 13).
Output. Chip Select provided for mapping of PHY functions into LAN91C111
nCSOUT O4 decoded space. Active on accesses to LAN91C111's eight lower addresses
when the BANK SELECTED is 7.
Transmit Current Set. An external resistor connected between this pin and GND
RBIAS NA
will set the output current for the TP transmit outputs.
TPO+ O/I Twisted Pair Transmit Output, Positive.
TPO- O/I Twisted Pair Transmit Output, Negative.
TPI+ I/O Twisted Pair Receive input, Positive.
TPI- I/O Twisted Pair Receive input, Negative.
nLEDB OD PHY LED Output.
nLEDA OD PHY LED Output.
Description
DN-V1700
21