OmniPod DASH SYSTEM PODDER Resource Manual page 17

1.4 + Leave Pod in its plastic tray
+ Insert the needle straight down
into the fill port on the underside
of the Pod. To ensure proper fill,
do not insert fill syringe at an
angle into the fill port
+ Completely empty the syringe
into the Pod
+ The Pod will beep twice,
indicating that the Omnipod
DASH System is ready
™
to proceed
+ Return to the PDM. If the PDM
screen times out, press the
Power button to turn it back on.
Place the PDM next to the Pod
so they are touching
+ Tap "NEXT"
Reminder
During activation and priming the PDM and Pod should be next to each
other and touching.
If the Personal Diabetes Manager screen times out during the process, press the Power button to continue.
OMNIPOD DASH
1.5 + The PDM establishes a
one-to-one relationship with
the Pod, which will prevent
it from communicating with
any other Pod while this
Pod is active. Once the Pod
successfully completes its
priming and safety checks,
the PDM will beep
SYSTEM INSTRUCTIONS |
™
2. Apply the Pod
2.1 + Select the infusion site, being
careful to avoid areas where
the Pod will be affected by
folds of skin. Refer to the Pod
Placement/Prep/Tips section
in this resource guide for sites
your healthcare provider
may recommend and
placement tips
Tip
Use Pod site map to help you
track your current and recent
Pod site locations. This feature
can be turned on in Settings.
Activate a New Pod