Valves; Io-Board - ProJet Hornet-III Instruction Manual

VALVES

To realize the automatic start you could connect a propane /kerosene valve.
Further there is the opportunity to plug in a smoker valve.

IO-BOARD:

To lengthen the in-and output port and the serial port the io-board could be plugged in between the ECU and
GSU. The board should be mounted on a good accessible position.
Buzzer:
Short signal
Long signal
Short interrupted signal
Status-LED:
Green
Orange
Red
Button:
By pressing the button in OFF-mode the pump is turned on manually.
: Power on message – GSU connected
: Begin autostart (open propane supply)
: Battery power alarm/Temp.-Sensor fault/Glow plug fault
(Symbol at GSU)
: OFF
: READY
: Engine in auto-mode
7