2-Adjustments - ProJet Hornet-III Instruction Manual

1.8 FUEL-VALVE PULSE
After successful ignition, the fuel supply will regulated with the entered value. Engine will exhaust with
less values.
1.9 GAS-EXPO
Setting of throttle stick – RPM-Curve. 0% = Linear (no EXPO) 100% = max. EXPO.
1.10 TEST GLOWPLUG
Glow plug test can be switched on or off during starting phase.
1.11 COOL DOWN TEMPERATURE
Engine will be cooled down to the entered temperature.
2-ADJUSTMENT
2.1 TEACH IN TRANSMITTER
The ECU has to learn the used transmitter. Listen to the following instructions:
1. THRO. LO/TRIM LO (THROTTLE/TRIM MINIMUM) Throttle-Stick and trim to minimum ->
2. THRO. LO/TRIM HI (THROTTLE MINIMUM/TRIMMING MAXIMUM) leave throttle-Stick at minimum,
Trimming to maximum ->
3. THRO. HI/TRIM HI (THROTTLE MAXIMUM/TRIMMING MAXIMUM) push Throttle-Stick to maximum,
leave trimming at Maximum ->
Ready.
If AUX-Channel is active (plugged in), the aux channel positions must be tea ched.
The plausibility will check up after adjustments. If an error message with a sound signal appears,
solve the problem and carry out the procedure again. The reason is mostly a wrong programming of
the transmitter.
2.2 ADJUSTMENT GLOW PLUG
Setting the voltage of the glow plug
16