Radio Control; Throttle Channel - ProJet Hornet-III Instruction Manual

RADIO CONTROL

THROTTLE
The throttle controls the engine:
Initiation starting sequence
Speed / Thrust controlling during flight
Shut-off
Before starting the engine, the radio control has to be teached in. (see Menu 2-Adjustments).
STARTING ENGINE:
1. Triming + throttle to maximum -> STANDBY
2. Throttle to minimum
3. Within 3 secs throttle to full -> STARTSEQUENCE
SPEED/THRUST CONTROLLING
After successful start-sequence and calibration the gas throttle controls the thrust of the engine.
SHUT-OFF
Engine is switched off to minimum by pushing back trimming (throttle idle).
RADIO CONTROL WITH DIGITAL TRIMING
To react very fast with digital trimming it is recommended to mix a switcher on the throttle channel or to use a
motor cut off switch. The switch replaces trimming, in this case trimming is without function and has to be left
on the maximum position.
FAIL SAFE
The incoming throttle channel pulses are permanent checked, if they are in valid limits. Upper and lower limits
will fixed in by teaching in the throttle channel. If a pulse is above or below this limits the fail safe function is
working.
In status display 1 the message „FAIL" appear.
22