ProJet Hornet-III Instruction Manual page 18

9.3 CALIBRATION SPEED
This speed will reached for calibration run after starting engine. This speed fix a crossing point between
slow /fast acceleration resp. delay(Menu 9.8 – 9.11)
9.4 CALIBRATION RATE
Input of pump voltage increasing rate during automatically calibration. If voltage is too high, flaming
results and calibration speed could be exceeded (9.3). This should be avoided! Is the adjusted value too
low, the automatic calibration is delayed.
9.5 CALIBRATION MAX. VOL TAGE
This max pump voltage must not be exceeded during auto. calibration. Engine will shut down -> see error
messages
9.6 CORRECTION FACTOR MAX.
To calculate the desired pump voltage at max., set in a multiplication factor.
ATTENTION ! Is this value to low, the max rmp will be reached verry slow at first attempt, overshoot if the
value too high.
9.7 CORRECTION STEP MAX
Are the differences in normative-actual state rpm the pump voltage will re-adjusted with this value. The
input happens in volt/sec.
ATTENTION ! If this value is choosen too low, the re-adjustment happens verry slow, is this value too high,
the closed loop regulator can swing, turbine could be shut down.
9.8 ACCELERATION SLO W
Time to accelerate engine from idle to calibration speed (Menu 9.3).
9.9 ACCELERATION FAST
Time to accelerate engine from calibration speed to max. rpm (Menu 9.3).
9.10 DELAY SLOW
Time to delay engine from calibration speed to idle (Menü 9.3).
9.11 DELAY FAST
Time to delay engine from max. rpm to calibration speed (Menu 9.3).
9.12 ACCELERATION / DELAY TEMPERATURE
If temperature rise per 1/10 per second is higher than the declared value, the fuel injection is delayed to
avoid overheating engine.
9.13 SPEEDSENSOR
Used sensor optical/magnetic – one or two pulse/rotation
9.14 IGNITION
Choice fuel or gas ignition
9.15 STARTER-V IGNITION
Starter Voltage to ignite engine
9.16 STARTER-V HEATING
Starter voltage during heating time
9.17 STARTER-V MAXIMUM
Max. starter voltage.
9.18 SPEED STARTER OFF
Rpm to decouple starter.
9.19 STARTER ACCELERATION
Value which starter voltage will increased per second, too high values could blow out engine.
18