Care And Cleaning - KitchenAid 3KSMC895 Manual

CARE AND CLEANING

• Unplug the Stand Mixer before
cleaning, or disconnect power�
• Stainless steel bowl, flat beater,
wire whip, and spiral dough hook
may be washed in an automatic
dishwasher� Or, clean them thoroughly
in hot sudsy water and rinse completely
before drying� Do not store beaters
on shaft�
• The bowl is dishwasher-safe� It can also be
hand washed in hot sudsy water, rinsed
thoroughly, and dried�
• Wipe the Stand Mixer with a clean damp
cloth� Do not use abrasive cleansers or
scouring pads and do not immerse the
Stand Mixer in water�
• Wipe the beater shaft frequently,
removing any residue that may
accumulate�
To Remove the Bowl Support
for Cleaning
1� Unplug Stand Mixer or disconnect
power�
2� Remove the Stand Mixer base by
removing the 3 screws located on
the bottom of the mixer� Remove
the vent screen and the mixer base�
3� Remove the nut from the lifter rod
located inside the column, then remove
the washer and spring�
NOTE: Note the order that they were
assembled (the washer goes between
the spring and nut), for reassembly�
14 | CARE AND CLEANING
Book 1.indb 14
4� Loosen the screw holding the
bowl clip to the front of the bowl
support – it is not necessary toremove the
screw all of the way�
This allows the bowl support to
slide down�
Screw
5� Slide the bowl support down so that the
tabs on the back of the bow support line
up with the slots in the column� Remove
the bowl support by passing the tabs
through the slots�
Screws
6� Clean the bowl support and column
with a mild detergent and a wash
cloth� Do not use abrasive cleansers
or scouring pads�
7� To reassemble, reverse steps
1 through 5�
Nut
5/30/2018 8:44:12 PM