Bartington Grad-13 Series Operation Manual page 38

Appendix A: Guidance for Connection to Mains Supply
1. Ensure that the mains feed is from a clean AC supply with the following characteristics:-
Voltage Range
Frequency
It is highly recommended that this mains feed is via an appropriate Residual Current Circuit
Breaker, rated at 30mA trip current. This must comply with local regulations.
2. The mains input connectors are as follows:
Device
8-Way Multiplexing Box
Battery Box
These cables are available in specific versions for most countries.
3. If an un-terminated IEC connector lead is supplied with the equipment, the wires must be
wired accordingly:-
BROWN
BLUE
GREEN/YELLOW
4. It is recommended that the mains to each unit is supplied via an 13A mains fuse:
This is appropriate for the use over the whole supply voltage range.
DCN1040
BARTINGTON INSTRUMENTS
100V to 240V AC (Selectable on Charger)
50/60Hz
Input Connector
IEC C14
IEC C8
LIVE
NEUTRAL
EARTH
Page 38 of 39
Mating Cable Connector
IEC C13
IEC C7
OM3100/2