8.2.4.1. Connecting to a Grad-13
Connect: The 'Connect' button is used to connect the software to the Grad13, the device
connection window shown in Figure 8 will then be displayed.
Note: the Grad 13 needs to be plugged in and powered before trying to connect.
This window allows you to connect to a Grad-13 device, if the connection has already been
correctly configured. All connections that are currently available are listed in the drop down list
box at the top of the window. If this is blank, then you will need to configure a new connection.
Click 'Connect' to attempt to connect to the Grad-13 device using the selected connection.
Note: the Grad 13 may not be listed in the drop down list if it has not been plugged in
before selecting 'Connect' from the main window.
DCN1040
BARTINGTON INSTRUMENTS
Figure 7: Visual Grad-13 Software Main Window
Figure 8: The 'Connect to a Grad-13' Window
Page 17 of 39
OM3100/2