Bartington Grad-13 Series Operation Manual page 30

BARTINGTON INSTRUMENTS
To set up a new connection or to choose which Grad13 to connect, select the 'Connect' button
and a new window, shown in figure 27, will pop up.
Figure 27: Grad-13 Connection Window
This window allows you to select and choose which Grad-13 to connect. The desired Grad-13
can be chosen from the list and then connected using the 'Connect' button. The window in figure
26 will then display 'Connected' next to the Grad-13 if successful. If an error is displayed, the
settings for this Grad-13 will need to be reviewed by selecting 'Configure Connections'.
If no Grad-13 gradiometers have been set up, they will need to be added using the 'Configure
Connections' button. This button will display the window in figure 28.
Figure 28: Adding Grad-13 connections
'Add': use this button to add a new connection, see figure 29.
'Edit': this button can be used to edit an existing selection, which can be chosen from the list on
the left hand side of the window.
DCN1040 Page 30 of 39 OM3100/2