Suspend Mode (2 Minutes) - Stanley M200 Setup & User Manual

Using the Monitor

Suspend Mode (2 Minutes)

Suspend Mode is used to allow the caregiver 2 minutes to remove a
patient/resident from a monitored pad without triggering any alarms.
If the patient/resident's weight is applied to the pad while in Suspend
mode, normal operation is not resumed - other than duration, that
is the difference between Hold and Suspend. A positive tone is heard
and the amber blinking stops.
Note:
The Suspend function (DIP switch position 3B) must be enabled.
See "DIP Switch Settings" on page 15. Hold mode can also be
used when Suspend mode is enabled by pressing for 2 seconds.
When a Positive Confirmation Tone is sounded and if the button
is released at that time, then the monitor moves to Hold mode. If
you continue to press for 2 more seconds, the monitor moves to
Suspend mode.
1.
While the patient/resident is being monitored on the pad, press
and hold the Reset Button on the monitor for 4 seconds. An
audible indication "Suspend mode 2 minutes" is announced.
2.
A 2-minute timer is set. The patient/resident can now be
removed from the pad without triggering an alarm.
3.
The Reset Button flashes amber
seconds.
seconds to warn that the Suspend mode is about to end. When
Suspend mode is over, an audible Positive Confirmation Tone is
sounded.
4.
To move out of Suspend mode before the 2 minutes has passed,
press and hold the Reset Button for 2 seconds. The Reset Button
stops blinking.
5.
When the timer runs out, the monitor resumes normal
operation.
24
A rapid blinking (once per 0.5 sec) occurs in the last 5
M200 Fall Monitor – Setup & User Guide
once per two seconds for 115