Speaker; Reset Button; Front Panel Status Indicators - Stanley M200 Setup & User Manual

Hardware Features

Speaker

The speaker allows the Monitor alarm (and recorded
message, if added) to be audible.

Reset Button

The Reset Button is used to display the monitor's status
without disrupting the monitoring session, to cancel
audible alarms, and to put the monitor into Hold or
Suspend Mode. Hold or Suspend Mode is used to suspend
patient/resident monitoring to allow staff to move the
patient/resident temporarily (adjust bedding, trip to the toilet, etc.)
Button press duration variations are as follows:
• A single press is used to hear the monitor's Delay status or cancel any
audible alarms.
• Two presses are used to set the delay. See "Setting the Alert Delay"
on page 5.
• A 3 second press is used to place the monitor in Hold Mode for 30
seconds. See "Hold Mode (30 Seconds)" on page 23.
• A 5 second press is used to place the monitor in Suspend Mode for
2 minutes (120 seconds). See "Suspend Mode (2 Minutes)" on page
24.

Front Panel Status Indicators

The front panel Status Indicators include the following 3 icons:
• Alert Delay 1s
• Alert Delay 2s
• Low Battery
4 M200 Fall Monitor – Setup & User Guide