Stanley M200 Setup & User Manual page 11

Alert Delay Icons (1 second and 2 second)
When the Alert Delay is set to 1 or 2 seconds, the corresponding icon
will be lit (blinking when using battery only). If the delay is set to 0
seconds, no icon will be lit.
Setting the Alert Delay
The Alert Delay is set by a sequence of presses on the Reset Button as
follows:
1. A single press (when not in Alarm mode) results in the following
audible indication: "Alarm Delay is X seconds." For example, if the
delay is set to 2 seconds, you will hear "Alarm delay is 2 seconds."
2. Two presses (see Note below) while not in alarm mode changes the
delay setting from the current setting to a new one (i.e., cycles through
from 0s to 1s to 2s, then back to 0s etc.):
a. '0' second delay will be changed to '1' second delay and the
following audible indication will be played: "Alarm Delay is set to 1
second." The 1s icon will be lit (blinking when using batteries only).
b. '1' second delay will be changed to '2' seconds delay and the
following audible indication will be played: "Alarm Delay is set to
2 seconds." The 2s icon will be lit (blinking when using batteries
only).
c. '2' second delay will be changed to '0' second delay and the
following audible indication will be played: "Alarm Delay is set to
0 seconds." No icon will be lit.
Note:
In the two presses required for changing the Delay settings, a
short pause is required between the two presses (i.e., do not
perform a "double-click.")
M200 Fall Monitor – Setup & User Guide
Hardware Features
5