Using Sensormat Pads - Stanley M200 Setup & User Manual

Using Sensormat Pads

Note:
The monitor has the ability to connect two pads at one time, but
is intended to only monitor a single patient/resident with the other
pad available for transfer of the patient/resident from one pad to
the second. A Negative Confirmation Tone is sounded if weight is
placed on both connected pads at the same time.
Sensormat pads are designed to sense body-weight distributed over
an area. Place the Sensormat pad either on a bed or chair, directly
underneath the patient/resident.
Only use Sensormat pads manufactured by STANLEY Healthcare
for use with the M200 Monitor. See "Other Components Sold
Separately" on page 1.
Pad testing should be done either by sitting or lying on the pad, or by
pressing down firmly with the palm of your hand.
For more information on pad testing see "Testing the Sensormat Pads"
on page 20.
Note:
Pads are for single patient/resident use and should be replaced on
or before their warranty period expiry date (calculated from date of
In-Use).
Refer to each pad's instructions for use printed on the pad.
M200 Fall Monitor – Setup & User Guide
Using Sensormat Pads
17