Recording Custom Pad Alarms - Stanley M200 Setup & User Manual

Monitor Setup

Recording Custom Pad Alarms

Note:
The Voice Recording Alarm feature (DIP switch position 1B) must
be enabled in order to allow a recording to be made. See "DIP
Switch Settings" on page 15.
Microphone
The Playback and Record buttons are found on the back of the
monitor. The microphone is located outside the battery compartment
as shown above.
1.
Press and hold the Record button, beside the microphone icon.
The Red LED flashes while the button is depressed, indicating
that the device is recording.
2.
Speak in a clear voice towards the microphone (not more than
about 10 cm [4 inches] away) and release the microphone
button when finished; the Red LED will stop flashing.
3.
Press the Playback button to hear the recorded message.
Note:
Messages can be recorded at any time except during an alarm.
Note:
Recorded message length can be up to a maximum of 15 seconds
at which time a Positive Confirmation Tone sounds indicating the
recording time is over.
14
Playback Button
M200 Fall Monitor – Setup & User Guide
Recording
Red LED
Record Button