Table of Contents
Advertisement
2
2-29 Packing the printer for shipping
Packing the printer for shipping
Pack the printer in the original packing materials, if possible. If you do not have
the original packaging, pack the printer with highly protective shipping material.
T
O PACK THE PRINTER FOR SHIPPING
1.
Remove the silicone oil, toner cartridges, drum cartridge and waste toner bottle
from the printer.
It is important that the above procedures are performed properly, so as not to
!
damage the printer or cause bodily harm. Refer to Appendix C of the User Guide
for complete instructions on how to complete these procedures.
2.
Tape the front and side doors of the printer shut so they will not open during
shipping.
3.
Wrap the printer in the plastic bag that came with the unit or with a new one if
the original was damaged. Use tape similar to the one originally shipped with the
unit to seal the plastic bag.
4.
Place the bottom sheet of cardboard on the shipping pallet, and place the bottom
corner protectors on the cardboard, matching up the numbers on the corner
protectors with the numbers on the cardboard.
Each corner protector is unique and is numbered from 1 to 4.
5.
Place the printer on the protectors.
6.
Place the top cardboard and corner protectors on top of the printer.
The protectors are numbered 1 to 4 and coincide with the numbers on the top
cardboard. The protectors slide into the slots.
7.
Place the accessory tray on top of the printer.
8.
Place the documentation and media pack in the accessory tray.
9.
Slide a new overpack box on top of the entire assembly.
This overpack box has the Digital logo on it. Make sure that the overpack box
seats properly on the pallet. The pallet has corners for aligning the overpack box.
:
Advertisement
Table of Contents
