Deleting A Programmed Time; Reseting All Programmed Times - Redback A 2078B Operating Manual

Setup
The cursor will be positioned over the hour section of the time. Use the up and down buttons to change the hour and then
press the "Enter Button" to confirm the hour. The cursor will move to the minutes section of the time. Use the up and down
buttons to change the minutes and then repeat the process again for the seconds. Once the seconds have been updated
the cursor will move to the day of the week. Use the up and down buttons again to change the day and then press enter
to confirm. The time is now set.

2.6 DELETING A PROGRAMMED TIME

P
ress the "Menu" button on the front of the timer. The unit is now in "Menu Mode" and the screen should display the
"Times Adjust" Screen. This is the first of 5 sub menu screens which are navigated by pressing the up and down buttons
as shown in Fig 2.19. Pressing the Menu button again will exit the menu structure and return the user to the Main Screen.
Select the DELETE TIMES sub menu.
After selecting this option, the screen as shown in Fig 2.22 should appear.
From this point the "Up" and "Down" buttons can be used to scroll through the different times, or press the "Enter" but-
ton to delete this time. After deleting the time, a message will indicate that the time has been cleared and the next time
will then be displayed on the screen. Press "Enter" to delete, "Menu" to exit or the "Up" and "Down" buttons to scroll to
another time.
A time can also be deleted using the PC software.
See section 2.4 for instructions regarding accessing the event programming. A time can be removed by double clicking on
the required programmed line and then pressing the "CLEAR" button.
2.7 RESET ALL PROGRAMMED TIMES
P
ress the "Menu" button on the front of the timer. The unit is now in "Menu Mode" and the screen should display the
"Times Adjust" Screen. This is the first of 5 sub menu screens which are navigated by pressing the up and down buttons
as shown in Fig 2.19. Pressing the Menu button again will exit the menu structure and return the user to the Main Screen.
Select the RESET ALL TIMES sub menu.
After selecting this option, the screen as shown in Fig 2.23 should appear.
Press the "UP" button to reset all the times programmed and stored on the SD card. Press the "No" button to exit without
resetting the times.
www.altronics.com.au
Redback® A 4500A Evac Controller & Timer
EDITING CLOCK
Fig 2.20
00:00:00
TIME1
Fig 2.22
07:55:00
RESET ALL TIMES
Fig 2.23
UP=YES / DN = NO
Mon
PREBELL
DELETE?
Redback® Proudly Made In Australia 17