Setting The Current Time - Redback A 2078B Operating Manual

Redback® A 4500A Evac Controller & Timer
Press the OK button and the second event now appears in the programming screen as shown in fig 2.18.
As the events are added they will be listed in chronological order. (I.e. In time order). If a new event was programmed, to start
at 08:45:00 for instance, this new event would appear before the prebell event.
Continue to enter the events in this manner and then save the program by clicking file and then save as. The file must be
saved as config.cnf on the SD card in place of the file already on the SD card.
With the events now programmed on the SD card, the card can be removed from the PC following windows safe card remov-
al procedures. Make sure the A 4500A is OFF and insert the SD card into the slot in the rear; it will click when fully inserted.
The A 4500A can now be switched back On. If all is well, after
the startup screen is displayed the current time and next event
should be displayed on the screen.

2.5 SETTING THE CURRENT TIME

P
ress the "Menu" button on the front of the timer. The unit is
now in "Menu Mode" and the screen should display the "Times
Adjust" Screen. This is the first of 5 sub menu screens which
are navigated by pressing the up and down buttons as shown
in Fig 2.19. Pressing the Menu button again will exit the menu
structure and return the user to the Main Screen.
Select the CLOCK ADJUST sub menu.
After selecting this option, the screen as shown in Fig 2.20
should appear.
16 Redback® Proudly Made In Australia
Fig 2.18
Main Screen
00:00:00
NO TIME__00:00:00
Press the UP and DOWN
buttons to scroll up and
down.
Enter
Press the ENTER
button to make your
selection
Menu
Press the MENU
button to exit at any
time.
Fig 2.19
Mon Menu MENU
1)TIMES ADJUST
MENU
2) CLOCK ADJUST
MENU
3)DELETE TIMES
MENU
4)RESET ALL TIMES
MENU
5)EV CHANGEOVER
www.altronics.com.au
Setup