Redback A 2078B Operating Manual page 13

Redback® A 4500A Evac Controller & Timer
Setup
Fig 2.12
The program can be run on the SD card or it could be copied to the PC desktop or another folder and run from there. Double
click on the file - RedbackA4500TimerProgrammer. The programming screen should appear as shown in fig 2.13.
If the program doesn't run then the .NET Framework might need to be updated on your PC.
This must be updated to the .NET Framework 4, available on the microsoft website.
Fig 2.13
All 50 events can be accessed on the screen by scrolling up and down. If you previously saved some timing information
using the buttons on the A 4500A then these times should be displayed. Otherwise the timing information should all be
blank as shown. The information is saved in a file labelled "config.cnf". This file should already be supplied on the SD card
and should be blank as shown.
Entering the timing events is very straight forward.
Double click on any line and a new window should pop up as shown in fig 2.14, which has the event details outlined.
www.altronics.com.au Redback® Proudly Made In Australia 13