Image Setting Screen (Main, Sub) - Ikegami MLW-3226C Instruction Manual

5.8 Image Setting Screen (Main, Sub)

This screen is used to adjust the contrast, brightness and other video signal-related display
conditions.
Screen display
Status User Display
Contrast
Brightness
Sharpness
Edg Freq
Noise Reduction
Hue
Chroma
Blue Only
Video Setup
IP Mode
UNDO
○ IN1: CH name - Signal name
IN2: CH name - Signal name
Image setting screen description
• Contrast
• Brightness
• Sharpness
• Edg Freq
• Noise Reduction : Used to reduce noises.
• Hue
• Chroma
• Blue Only
• Video Setup
Image Color Memory P-Pre
50
50
0
Low
OFF
0
64
OFF
0
Still
Switch behavior description
: Used to adjust the signal's white level gain.
Increase the setting to get images brighter, and decrease it to get
them darker.
: Used to adjust the signal's black level gain.
Increase the setting to get the black level higher, and decrease it
to get it lower.
: Used to adjust the sharpness.
Increase the setting to get images shaper, and decrease it to get
them softer.
: Use to adjust the frequency of sharpness.
: Used to adjust the hue.
: Used to adjust the color density.
Increase the setting to get the colors stronger, and decrease it to
get them weaker.
: Set it to ON, and the blue color only appears.
Feed the color bar signal and use this function, and the chroma
and hue adjustments can be easily made.
: Used to select the setup level of composite and Y/C signals.
0 : Offset set at 0%.
Mid : Offset set at 3%.
Hi : Offset set at 7.5%.
0 - 100
0 - 100
0 - 22
Low/Mid1/Mid2/High
OFF/Weak/Middle/Strong
-15 - +15
0 - 128
OFF/ON
0/Mid/Hi（Video/S-Video only）
Still/Motion/Still2/Motion2
15
5. Operation