Removing The Rear Cover; Removing The Right Guide Unit; Removing The Horizontal Registration Motor; Punch Unit - Canon Puncher Unit-P1 Service Manual

3.2.2.2 Removing the Right
Guide Unit
1) Remove four screws [1], and remove the right
guide assembly [2].
3.2.2.3 Removing
Horizontal
Motor
1) Disconnect the connector [1].
2) Remove two screws [2] and slide the horizontal
registration motor [3] in the direction of the arrow to
remove.
F-3-8
0003-6797
F-3-9
the
Registration
0003-6798
F-3-10

3.2.3 Punch Unit

3.2.3.1 Notification
dismounting the Punch Unit
When removing the punch unit, the punch unit
section sometimes opens. If necessary, perform
work with the punch unit section in an open state.
3.2.3.2 Removing the Rear
Cover
1) Remove three screws [1] and remove the rear cover
[2].
F-3-11
Chapter 3
when
0003-8233
0003-6800
3-3