3.3 Electrical System
3.3.1 Punch Unit Harness
3.3.1.1
Notification
dismounting the Punch Unit
Harness
When removing the punch unit, the punch unit
section sometimes opens. If necessary, perform
work with the punch unit section in an open state.
3.3.1.2 Removing the Rear
Cover
1) Remove three screws [1] and remove the rear cover
[2].
F-3-23
3.3.1.3 Removing the Right
Guide Unit
1) Remove four screws [1], and remove the right
guide assembly [2].
when
0003-8728
0003-6804
0003-6805
F-3-24
3.3.1.4 Removing the Upper
Cover
1) Open the front door [1], remove three screws [2],
and remove the upper cover [3].
F-3-25
3.3.1.5 Removing the Punch
Unit Harness
1) Disconnect the two connectors [2] on the punch
controller PCB [1] and remove the harness from the
edge saddle [3].
Chapter 3
0003-6803
0003-6807
3-7