4Swithcing The Paper Size Of The Deck; Swithcing The Paper Size Of The Deck - Canon Paper Deck-V1 Portable Manual

Chapter 2
2.1.4 Swithcing the Paper
[2] [1] [3]
Size of the Deck
0009-4846
If the deck paper size configuration must be changed
to suit the needs of the user, perform the following:
1) Open the compartment [1] of the paper deck, and
remove all copy paper.
2) If the lifter of the paper deck in in up position, turn
on the host machine's power switch, and push the
lever of the paper supply level sensor [2] inside the
[4]
compartment so that the lifter will move down to its
F-2-5
lower limit.
[1]
[2]
F-2-4
3) Remove the screw [1], and move the paper trailing
edge guide plate [2] to suit the new paper size; then
secure it in place with a screw. (The rear end guide
plate will not be used for LTR size. The paper sizes
are marked on the bottom deck.)
4) Detach the front cover of the paper deck.
5) Remove the screws (one each) [3], and mount the
left right guide plates [4] to suit the new paper size.
6) Mount the front cover of the paper deck.
7) Set COPIER>OPTION>ACC>DK-P in the host
machine's service mode.(0:A4, 1:B5, 2:LTR)
2-2