Advertisement
Quick Links
Download this manual
See also:
User Manual
VEO-XTI1C / VEO-XRI1C
VEO-XTI2L / VEO-XRI2L
How to configure a Cisco SG300 Ethernet Switch for Ecler
VEO over IP products
QUICK START GUIDE
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Ecler VEO-XRI1C
Summary of Contents for Ecler VEO-XRI1C
-
Page 1: Quick Start Guide
VEO-XTI1C / VEO-XRI1C VEO-XTI2L / VEO-XRI2L How to configure a Cisco SG300 Ethernet Switch for Ecler VEO over IP products QUICK START GUIDE... - Page 2 INDEX Establishing communication with the Cisco Ethernet Switch ........3 Enabling IGMP Protocol ......................3 Enabling Jumbo Frame......................7 Configuring the DHCP Server ....................7...
- Page 3 1. Establishing communication with the Cisco Ethernet Switch 1. Connect your computer to the Cisco Ethernet Switch using an Ethernet cable. The Cisco SG300 Ethernet Switch comes with a default Static IP address of 192.168.1.254; you must configure your PC with a Static IP address in the same subnet.
- Page 4 2. Select Multicast → IGMP Snooping. Enable the IGMP Snooping Status by activating the related selection box and clicking on Apply. 3. In the IGMP Snooping Table, select the default VLAN ID 1 and click on Edit.
- Page 5 In the resulting window, activate the related selection box for IGMP Snooping Status and verify that the Immediate Leave selection box is enabled and then click on Apply. 5. Select Administration → File Management → Copy/Save Configuration. Enable Running Configuration and Startup Configuration as shown below and save all changes by clicking Apply.
- Page 6 6. Select Administration → File Management → Reboot, and click on the Reboot button to reboot the Ethernet switch and make all the changes running.
- Page 7 3. Enabling Jumbo Frame 1. Select Port Management → Port Settings. Enable Jumbo Frames by activating the related selection box and click on Apply. 4. Configuring the DHCP Server The DHCP Server will automatically configure the IP addresses of each device connected to the switch.
- Page 8 1. To change the Ethernet Switch Static IP address to the same subnet as the AV over IP Devices, select Administration → Management Interface → IPv4 Interface. Set IP Address Type to Static, and enter the IP Address (accordingly to your network requirements), and set the Network Mask to 255.255.255.0.
- Page 9 3. Set the Pool Name, the Network Mask (255.255.255.0), the Address Pool Start (192.168.1.10), and the Address Pool End (192.168.1.100). Verify that you allocate enough IP addresses for all Transmitters and Receivers present on the network. Click on the Apply button.
- Page 10 4. Select IP Configuration → IPv4 Management and Interfaces → DHCP Server → Properties. Enable the DHCP Server Status by activating the related selection box and clicking on Apply.
- Page 11 5. Select Administration → File Management → Copy/Save Configuration. Enable Running Configuration and Startup Configuration as shown below and save all changes by clicking Apply. 6. Select Administration → File Management → Reboot, and click on the Reboot button to reboot the Ethernet switch and make all the changes running.
- Page 12 NEEC AUDIO BARCELONA S.L. reserves the right to make changes or improvements in the design or manufacturing that may affect these product specifications. Motors, 166‐168 08038 Barcelona ‐ Spain ‐ (+34) 932238403 | information@ecler.com www.ecler.com...
Need help?
Do you have a question about the VEO-XRI1C and is the answer not in the manual?
Questions and answers