Locations And Functions Of Parts; Accessory Attachments; Controls And Connectors - Sony HDC3500 Operating Instructions Manual

Locations and Functions of Parts

Accessory Attachments

p
o
n
m l
a VF (viewfinder) connector (20-pin)
Connect the cable of the viewfinder (not supplied).
b Shoulder strap fitting post
Attach one end of a shoulder strap (not supplied) to this fitting
post, and the other end to the fitting post on the other side of
the camera.
c Accessory shoe
To attach an accessory using a 1/4-inch screw.
d Viewfinder left-right positioning ring
Loosen this ring to adjust the viewfinder position towards the
left or right.
e Viewfinder front-rear positioning lever
Unlock the front-rear positioning lever to adjust the viewfinder
position towards the front or rear, then lock in the desired
position.
For details on adjusting the viewfinder position, see "Attaching
a Viewfinder" on page 12.
f Lens cable clamp
To secure the cable of the lens (not supplied).
g Lens fixing lever
To secure the lens in the lens mount.
h Lens mount cap
The cover can be removed by moving the lens fixing lever
upwards. Always keep the lens mount covered with this cap
when a lens is not attached.
i Lens mount
To attach a lens.
j LENS connector (12-pin)
Connect the lens cable. The camera can control the lens
functions through this cable.
k Tripod mount
Attach the VCT-14 Tripod Attachment when mounting the
camera on a tripod.
l LED lamp
a
Use as a tally. You can switch the function using the menu.
b
m Camera number
c
The unit uses electronic paper (e-ink) type camera numbers.
You can set the camera number using the menu.
d
e
Note
The operating temperature range of the camera number
setting is 0 °C to 45 °C (32 °F to 113 °F). The setting may not
f
be configurable if the temperature range is exceeded. Check
g
the temperature when configuring.
h
n Shoulder pad
You can adjust the position so that you can get the best
i
balance for shooting with the camera on your shoulder.
j
For details, see "Adjusting the Shoulder Pad Position" on
page 14.
k
o Microphone holder attachment
Use to attach a CAC-12 Microphone Holder.
For details, refer to the microphone holder operation manual.
p V-wedge shoe attachment points
Attach a V-wedge shoe here to mount an HDVF-EL75/L750/
L770 Viewfinder.
Note
Select either the front or rear V-wedge shoe attachment points
to attach the V-wedge shoe. If the front position is used, it may
restrict the tilt/pan angle available for the viewfinder.
For details about attachment, refer to the operation manual of
the viewfinder.

Controls and Connectors

Front right
a
b
c
d
e
f
6
g
h
i
j
k
l