Location And Functions Of Parts And Controls - Sony SNC-DF40N Installation Manual

Location and
Functions of Parts
and Controls
Front
a Indoor wiring slit (knockout
type)
When you wire indoors, cut this part
with a nipper or similar and feed the
cable through it.
Note
Take care not to trap the cable between
the camera and the ceiling or the wall. If
the cable is trapped, it may cause a fire
or electric shock due to breaking.
b Tilt angle adjustment screw
Loosen this screw before adjusting the
lens position, and tighten it to fix the lens
position.
10
GB

Location and Functions of Parts and Controls

1
2
5
3
4
c Zoom lever
Move this lever to adjust the field of
view. As the lever itself is a screw,
tighten it to fix its position.
d Focus lever
Move this lever to adjust the focus. As
the lever itself is a screw, tighten it to fix
its position.
e Lens
Rear
(When the dome dcover is removed)
6
LED ON
OFF
qa
MON
qs
LED ON
OFF
f Dome cover screw hole
This is a ground terminal for the chassis.
g NETWORK indicator (orange/
green)
The indicator flashes in orange when the
camera is connected to the 10BASE-T
network; it flashes in green when the
camera is connected to the 100BASE-
TX network.
The indicator goes off when the camera
is not connected to the network.
7
8
NETWORK
POWER
RESET
9
0