Location And Functions Of Parts And Controls - Sony Ipela SNC-DF70N Installation Manual

Location and Functions of Parts and
Controls
The figure shows the camera without the dome casing and slit cover.
Side
7
8
9
a 24V AC/12V DC (power input)
cable
Connect to a 24V AC or 12V DC power
supply system.
b BNC cable
Outputs a composite video signal.
Connect to a composite video input
connector of a video monitor, VCR, etc.
c Conduit holes (
Connect a pipe to this hole. There are
two conduit holes on the unit casing, one
on the side and one at the bottom. The
cover plug is installed in the side conduit
hole at the factory. Remove the plug as
needed and connect the pipe to the hole.
3
/ inch)
4

Location and Functions of Parts and Controls

d Tilt angle adjustment screw
Loosen this screw before adjusting the
lens position, and tighten it to fix the lens
position.
e Zoom lever
Move this lever to adjust the field of
view. As the lever itself is a screw,
tighten it to fix its position.
f Focus lever
Move this lever to adjust the focus. As
the lever itself is a screw, tighten it to fix
its position.
g Audio cable
The connector with the longer cable is
used for the line output connector, and
the other cable is used for the
microphone input connector.
1
2
3
4
5
6
11
GB