Inserting A Cassette; Using A Card (Nv-Gs15 Only) - Panasonic NV-GS 8 EGE Operating Instructions Manual

15EGE-ENG.book 12 ページ ２００４年２月９日 月曜日 午前１１時１０分

Inserting a Cassette

1
Slide the [OPEN/EJECT] Lever
the front and pull down to fully open the
Cassette Compartment Cover.
≥To protect the tape, if the cover is not fully
opened, the cassette cannot be ejected.
2
Insert a Cassette.
3
Close the Cassette Holder by pressing the
[PUSH] mark 1.
1
PUSH
4
Close the Cassette Compartment Cover.
ª Accidental Erasure Prevention
Opening the accidental erasure prevention slider
1 on the cassette (by sliding it to the [SAVE]
arrow direction) prevents recording. To enable
recording, close the accidental erasure
prevention slider (by sliding it to the [REC] arrow
direction).
1
R E C
SAVE
≥For other notes concerning this item, see
Before Use

Using a Card (NV-GS15 only)

(38) toward A Card can be used to record pictures.
Before inserting or removing a Card, be sure
to turn off the Movie Camera.
≥Otherwise, the Movie Camera may not function
properly or it may cause the loss of recorded
data in a Card.
(38)
ª Inserting a Card
1
Slide the [OPEN] Lever
Slot Cover
2
While holding the Memory Card with its cut
corner facing right 1, insert it into the Card
Slot (4)
3
Close the Card Slot Cover
Removing the Card
Open the Card Slot Cover and press the centre of
the Card and then pull it straight out.
≥After removing the Card, close the Card Slot
Cover.
≥The Movie Camera may be damaged if the
Card is forced out when the Card is fully
inserted.
ª Card Access Lamp
(14)
While the Movie Camera is accessing the Card
(reading, recording, playback or erasing), Card
Access Lamp lights up.
≥While Card Access Lamp is on, never attempt
to open the Card Slot Cover, to pull out the
Card, to turn off the Movie Camera, or to turn
.
-47-
the Mode Dial. Such actions will damage the
Card, and recorded data, and cause the Movie
Camera to malfunction.
-12-
(3) to open the Card
(5)
.
(3)
(5)
OPEN
.
(4)
1
(5) securely.
(14)
RESET