Notes And Hints - Panasonic NV-GS 8 EGE Operating Instructions Manual

15EGE-ENG.book 47 ページ ２００４年２月９日 月曜日 午前１１時１０分
PUSH THE RESET SWITCH:
An irregularity in the mechanism has been
detected. Press the [RESET] Button
( , ). This may solve the problem.
-6- -58-
CARD FULL:
Card does not have sufficient memory
remaining.
Select Picture Playback Mode and delete
unnecessary files.
NO CARD:
Card is not inserted.
NO DATA:
There is no recorded files in the Card.
UNPLAYABLE CARD:
You are attempting to play back a data
which is not compatible with this Movie
Camera.
CARD ERROR:
This Card is not compatible with this Movie
Camera.
COPY INHIBITED:
Because the medium is protected by a copy
guard, images cannot be recorded
correctly.
INCORRECT OPERATION:
The Recording Start/Stop Button is pressed
without connecting the USB cable to the PC
in Picture Playback Mode.
CAN NOT USE USB CHANGE MODE:
The USB cable is connected to the Movie
Camera in Card Recording Mode or Picture
Playback Mode.
CAN NOT OPERATE:
You are attempting to record pictures on a
Card with connecting the USB cable to the
Movie Camera in Tape Recording/Playback
Mode.
UNABLE TO WRITE
(MULTI RECORDING):
The [PHOTO SHOT] Button is pressed
when you are recording pictures on a Tape
with setting the Digital Effect [MULTI] of
[EFFECT1].
UNABLE TO WRITE:
The Recording Start/Stop Button is pressed
when you are recording still pictures on the
Card.
CASSETTE DOOR OPENED:
Close the Cassette Compartment Cover
before recording.
NO TITLE:
Titles are not recorded.
UNABLE TO WRITE
(WIDE MODE):
You are attempting to record pictures of S1
signal (with aspect ratio 16:9) by pressing
the [PHOTO SHOT] Button.
Others
FILE LOCKED:
You are attempting to erase protected
pictures.
CARD LOCKED:
The write protection switch on the SD
Memory Card is set to [LOCK].
DISCONNECT USB CABLE:
You are attempting to turn the Mode Dial or
turn the Movie Camera off in PC Mode with
connecting the USB cable to the Movie
Camera.

Notes and Hints

ª Concerning the Power Supply
≥When the Movie Camera is used for a long time,
the Camera body becomes warm, but this is not
a malfunction.
≥If the [CHARGE] Lamp does not light up
although the Battery is attached to the AC
Adaptor, detach the Battery and reattach it.
ª Inserting/Removing the Cassette
≥In the case of using a previously recorded
Cassette, you can use the Blank Search
Function to find the position where you want to
continue recording.
≥If a new Cassette is inserted, rewind to the
beginning of the tape before starting recording.
≥When inserting the cassette, make sure it faces
in the right direction and then push it in until it
stops.
≥When the Cassette Holder is in action, do not
touch anything except the [PUSH] mark.
≥When closing the Cassette Compartment
Cover, do not get anything caught in the cover,
such as a cable of an optional stereo
microphone.
ª Alarm Sounds
When [BEEP SOUND] on the [INITIAL]
Sub-Menu on the [TAPE RECORDING MENU] is
set to [ON], confirmation/alarm beeps are issued
as follows.
1 Beep
≥When you start recording
≥When you switch the [OFF/ON] Switch from
[OFF] to [ON]
2 Beeps
≥When you pause recording
2 Beeps 4 times
≥If you perform a wrong operation before or
during recording
-47-