Replace The V-Axis Motor - RBCBioscience MagCore HF16 Plus Training Manual

Replace the V-axis motor

Open the front door.
1. Unplug the wire connector of the LED.
2. Loosen the three screws on the top of piston module (2.5mm Hex wrench), and take
off the LED module.
3. Screw off the eight screws of the acrylic nameplate at the front side (2.5mm Hex
wrench).
4. Screw off the four screws of the reinforced metal sheet (1.5mm Hex wrench).
3
51
2
1
4