Location And Function Of Parts And Operation; Front/Top/Bottom; Using A Tripod - Sony XCG-CG160 Technical Manual

Location and Function of Parts and Operation

Front/Top/Bottom

a Lens mount (C-mount)
Attach any C-mount lens or other optical equipment.
Note
Use a C-mount lens with a protrusion (a) extending from
the lens mount face (b) of 10 mm (13/32 inch) or less.
The performance of a lens may change according to the
aperture level.
If the resolution is not enough, adjust the aperture level.
b Guide screw holes (Top)
c Guide screw holes/Tripod screw holes (bottom)
When using a tripod, use these four screw holes to attach
a VCT-333I tripod adaptor.
d Reference screw holes (bottom)
These precision screw holes are for locking the camera
module. Locking the camera module into these holes
secures the optical axis alignment.
Note
Refer to XCG-CG240 Demensions in page 59 for about
the position/size of the Guide hole and the Reference
hole.
a
b
7

Using a tripod

To use the tripod, install the tripod adaptor VCT-333I
(not supplied) on the camera module.
Use a tripod screw with a protrusion (4) extending from
the installation surface, as follows, and tighten it, using
a screwdriver. Be sure that the protrusion (4) does not
exceed 5.5 mm (0.2 in.) in length.
Length 4.5 to 5.5 mm
Length 0.18 to 0.22 inches
Note
If you install a tripod adapter (not supplied), use the
screws provided.