Burst Trigger - Sony XCG-CG160 Technical Manual

Bulk
SpecialTriggerSource=1, SpecialTriggerActivation=0, NumberOfMemoryForSpecialTriggerMode=3 in the figure.
Sequential
SpecialTriggerMode=2, SpecialTriggerActivation=0 in the figure.

Burst trigger

Exposure can be repeated with a single trigger signal. Two modes are available; a mode that repeats a single exposure
time and a mode that alternately repeats two exposure times.
Register
BurstMode Off(0)
SingleExposureTime(1) Upon trigger edge detection
DualExposureTime(2)
BurstPeriod FrameCount(0)
TriggerDuration(1)
BurstFrameCount 0 to 65533
BurstForceStop 1
Exposure2Time 1 to 60000000
Exposure2Ratio 1, 2, 4, 8, 16
Trigger signal
Exposure
Sensor output
Setting 1
Trigger signal
Exposure
Sensor output
Setting 1
Parameter
Upon trigger width detection Exposes for the range of trigger width.
Upon trigger edge detection
Upon trigger width detection Exposes for periods in trigger width and trigger
Exposes only the times set in BurstFrameCount.
Performs burst exposure while the input trigger is on. However, burst exposure would
be terminated when it reaches BurstFrameCount. Enabled when ExposureMode is in
edge detection mode. Disabled in width detection mode.
0: repeated unlimitedly
1 or more: exposure for designated times
Forced termination of repeated exposure
Second exposure time during trigger edge detection
Value to determine the second exposure time of trigger width detection. The first
exposure time (trigger width) multiplied by this value is the second exposure time.
Setting 2
Setting 2
5ms or
longer
Setting
Exposes for the period set in ExposureTime.
Exposes for periods set in ExposureTime and
ExposureTime2 alternatively.
width x Exposure2Ratio alternately.
27
Setting 3
Setting 3