Table of Contents
Advertisement
GPIO
GPI
The signal level which is input in the 2nd, 3rd, and 4th*
DC IN connector can be detected. After selecting a
connector by LineSelector register, the signal level is
acquired from LineStatus register.
* Only output is available for XCG-CG160/CG160C
GPO
Various signals can be output from the 3rd and 4th DC
IN connector. After selecting a connector by
LineSelector register and setting LineMode to Output,
LineSource is set. The output polarity is set by
LineInverter register.
Register
Parameter
Setting
LineSelector Line1 (0)
DC IN connector 2nd pin
Line2 (1)
DC IN connector 3rd pin
Line3 (2)
DC IN connector 4th pin
LineMode
Input (0)
Set to input
Output (1)
Set to output
LineInverter Off (0)
Without output inversion
On (1)
With output inversion
LineStatus
Input signal level
LineSource
TriggerThrough (0)
Trigger through signal
ExposureActive (1)
Exposure signal
StrobeActive (2)
Strobe control signal
SensorReadout (3)
Sensor readout signal
UserOutput1 (4)
User definition 1
UserOutput2 (5)
User definition 2
UserOutput3 (6)
User definition 3
SignalTrue (7)
Level H
SignalFalse (8)
Level L
PWM (9)
Pulse generation signal
ActionCommandPulse
Action command signal
(10)
FreeSetSequence (11) Free set sequence signal
Setting example:
The strobe control signal is output to GPO2 (DC IN
connector 3rd pin) by Hi active setting.
LineSelector = 1
LineMode = 1
LineInverter = 0
LineSource = 2
Page 41
- Quick Links:
- Features
- Connection
- Network Settings
Hide quick links:
Advertisement
Table of Contents
