Drive mode
"Mode 0" which prioritizes the frame rate is set by
default.
The frame rate upper limit of "Mode 0" is higher
than"Mode 1," but the usable functions are limited.
When correcting the defects/shadings in "Mode 0."
After detecting and saving the defects/shadings in
"Mode 1," return to "Mode 0" and use them.
Reboot the unit to reflect the changes of the drive mode.
command
parameter
DRIVE_MODE
DRIVE_MODE
Mode 0
Maximum frame
75 fps (XCG-
rate
CG160/CG160C)
41 fps (XCG-
CG240/CG240C)
23 fps (XCG-
CG510/CG510C)
Defect detection
–
function
Defect correction
z
function
Shading detection
–
function
Shading correction
z
function
Output format
See the "Output format" function.
Free set sequence
z
z Usable function
– Not usable function
Setting
0
Mode 0
1
Mode 1
Mode 1
50 fps (XCG-
CG160/CG160C)
32 fps (XCG-
CG240/CG240C)
15 fps (XCG-
CG510/CG510C)
z
z
z
z
–
16