Location And Function Of Parts And Operation; Front/Top/Bottom; Rear - Sony XCI-SX100C Technical Manual

Location and Function
of Parts and Operation

Front/Top/Bottom

2
1 Lens mount (C mount/CS mount)
Attach any C mount or CS mount lens, or other
optical equipment.
Note
The lens must not project more than the following
length-values from the lens mount.
1 Lens mount face
2 C mount: 10 mm (13/32 inch) or less
CS mount: 5 mm (7/32 inch) or less
2 Fall-prevention wire screw holes (top)/auxiliary
reference screw holes (top)
3 Tripod screw holes (top/bottom)
4 CompactFlash slot cover/CompactFlash slot
(internal)
The CompactFlash must be purchased separately.
5 Reference holes (bottom)
These precision screw holes are for locking the
camera in place. Using these holes secures the
optical axis alignment.
6

Rear

1
2
3
4
5
6 MONITOR (monitor output) connector (15-pin,
1
7 DIGITAL I/O connector (15-pin, male)
6 7
9 0
female)
You can connect a monitor cable to this connector
and display your computer's operating system on a
multiscan monitor.
Pin No. Signal
1 R OUT
2 G OUT
3 B OUT
4 NC
5 GND
6 GND
7 GND
8 GND
You can connect a DIGITAL I/O cable to this
connector to transmit data between the camera and
the control device.
Pin No. Signal
1 ISO_IN1
2 ISO_IN2
3 ISO_IN3
4 ISO_IN4
5 ISO_IN_COM
6 ISO_OUT1
7 ISO_OUT2
8 ISO_OUT3
8
qa qs qd qf qg
Pin No. Signal
9 NC
10 GND
11 NC
12 NC
13 HD OUT
14 VD OUT
15 NC
Pin No. Signal
9 ISO_OUT4
10 ISO_OUT_COM1
11 ISO_OUT5
12 ISO_OUT6
13 ISO_OUT7
14 ISO_OUT8
15 ISO_OUT_COM2