Rear; Connecting The Cables - Sony XCG-CG160 Technical Manual

Rear

e
(DC power input) connector (6-pin)
You can connect a camera cable to input the +12 V DC
power supply. The pin configuration of this connector is
as follows.
(Refer to Fig. above for the pin assignment of the
6
connector.)
Pin No. Signal
1 DC input (10.5 V
to 15 V)
2 GPI1 (ISO +)
3 GPI2/GPO2
*XCG-CG160/CG160C only
f RJ45 connector
You can connect a LAN cable to this connector to
control the camera module from a host device to output
image to a host device. By using a PoE-compatible LAN
cable and camera module interface board or hub, you
can supply power using the LAN cable.
Note
For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
g Reset switch
The camera can be reset to the factory setting by
pressing the reset switch for more than 3 seconds while
the power is turned on.
Notes
• All the setting items will be deleted.
• Formatting is performed after operation.
Do not turn off the power for 1 minute after the LED
lights again.
h Status LED (Green)
Displays the unit status.
For details, see "Status LED" (page 43).
Pin No. Signal
4 GPI3/GPO3
(GPO3 (ISO +)*)
5 ISO –
6 GND

Connecting the cables



Connect the camera cable (5) to the DC IN connector
(2) and connect the LAN cable (3) to the RJ45
connector (1) respectively. If you use a camera module
interface board or a hub that supports PoE, you can
operate the camera even if you do not connect the
camera cable to the DC IN connector. When you connect
the LAN cable with fastening screws, turn the two
screws (4) on the connector to secure the cable tightly.
Connect the other end of the camera cable to the DC-
700/700CE and the other end of the LAN cable to the
camera module interface board or a hub.
Note
Do not supply power to the camera cable and LAN cable
at the same time.
8


