Advertisement
Quick Links
Advertisement
Related Manuals for Falco FAL70GW
Summary of Contents for Falco FAL70GW
- Page 1 Cooker hood Instruction manual Model No.: FAL70GW...
- Page 2 Page 1 (Inside) Please be careful when removing and installing the Island installation Brackets and Stainless Steel chimneys. The Stain Less steel chimneys contains sharp edges and can possibly lead to cuts. Generally asked Questions and Answers: 1. Q: My extractor fan is not extracting A: before logging a service call please ensure the installation on your extractor fans was done properly to avoid a service call out fee charge.
- Page 3 You can also download it from www.falco.co.za 7. Q: How often do I have to replace my filters? A: With daily use we recommend that you replace your charcoal filters every 6 months. Your aluminium filters can be cleaned in luke warm water and dishwashing liquid.
- Page 4 11. Q: Why is there rust marks on my extractor? A: Stainless steel can rust if cleaned with abrasive cleaners. The chemicals inside abrasive cleaners react with the stainless steel and the result will be rust. There are many day to day cleaning products in our kitchens that are abrasive cleaners and unknown to the consumer.
- Page 5 A: Full range of spares are available from Lategan & Van Biljoens in Pretoria. www.appliancesspares.co.za 15. Q: What is the diameter of my ducting hose? A: 150mm 16. Q: More Queries? A: Please email any queries to: christie@falco.co.za, Tel: 011 454 6423/4314. Spares can be viewed and ordered online: www.appliancespares.co.za...
- Page 6 NOTICE 1. Thank you for choosing our cooker hood. Please read the instruction manual carefully before use. 2. The installation work must be undertaken by a qualified and competent fitter. 3. The manufacturer disclaims all liability for any damage or injury caused as a result of not following instructions for installation contained in the following text.
-
Page 7: Safety Warning
SAFETY WARNING Keep your children away from using the cooker hood. Your cooker hood is for domestic use only, not suitable for barbecue, roast shop and other commercial use. Any installation work must be carried out by a qualified electrician or competent person. -
Page 8: Installation
INSTALLATION 1.1 The cooker hood should be placed at a distance of 65-75cm (26-30inch) from the cooking surface for the best effect. See Pic 1. 1.2 Up extraction and back extraction could be choosed.When you choose back extraction,take down the back outlet panel and assemble the motor to the back,put the back outlet panel to the top.see Pic.2 &... - Page 10 2.1 Glass fitting and light replacing o Prior to touching the light bulbs ensure they are cooled down. o First unscrew the 4 screws securing the glass panel on the side of the appliance where you are changing the bulb. o Disconnect the light wiring connection point and push/pull the light out of the light fitting.
-
Page 11: To Use Your Cooker Hood
TO USE YOUR COOKER HOOD Electronic Button Before operating the hood, make sure that it has been installed by a suitably qualified person, as per the information contained in installation instructions. o Find the control panel, which is located under the front of the canopy. -
Page 12: Maintenance
IMPORTANT: IDEALLY YOU SHOULD SWITCH ON YOUR HOOD TEN MINUTES BEFORE YOU START TO COOK, OR AT THE VERY LEAST WHEN YOU BEGIN COOKING. YOU SHOULD ALSO RUN YOUR HOOD FOR TEN MINUTES AFTER YOU HAVE FINISHED COOKING. The cooker hood lights o The two LED lights can be switched on and off by pressing the light control button.
Need help?
Do you have a question about the FAL70GW and is the answer not in the manual?
Questions and answers