Subscribe to Our Youtube Channel
Related Manuals for Falco FAL-52-BIS
Summary of Contents for Falco FAL-52-BIS
- Page 1 Cooker Hood Instruction Manual Model no.: FAL-52-BIS / FAL-75-BIS FAL-52-BIG / FAL-75-BIG...
- Page 2 Page 1 (Inside) Please be careful when removing and installing the Island installation Brackets and Stainless Steel chimneys. The Stain Less steel chimneys contains sharp edges and can possibly lead to cuts. Generally asked Questions and Answers: 1. Q: My extractor fan is not extracting A: before logging a service call please ensure the installation on your extractor fans was done properly to avoid a service call out fee charge.
- Page 3 You can also download it from www.falco.co.za 7. Q: How often do I have to replace my filters? A: With daily use we recommend that you replace your charcoal filters every 6 months. Your aluminium filters can be cleaned in luke warm water and dishwashing liquid.
- Page 4 11. Q: Why is there rust marks on my extractor? A: Stainless steel can rust if cleaned with abrasive cleaners. The chemicals inside abrasive cleaners react with the stainless steel and the result will be rust. There are many day to day cleaning products in our kitchens that are abrasive cleaners and unknown to the consumer.
- Page 5 A: Full range of spares are available from Lategan & Van Biljoens in Pretoria. www.appliancesspares.co.za 15. Q: What is the diameter of my ducting hose? A: 150mm 16. Q: More Queries? A: Please email any queries to: christie@falco.co.za, Tel: 011 454 6423/4314. Spares can be viewed and ordered online: www.appliancespares.co.za...
- Page 6 Thank you for purchasing this cooker hood. Please read the instruction manual carefully before you use the cooker hood, and keep it in a safe place. The installation work must be carried out by a qualified electrician or competent person.
- Page 7 1. INSTALLATION 1) The cooker hood should be placed at a distance of 65-75cm (26-30inch) from the cooking surface for the best effect. 2) Drill a hole in the cabinet, with hole wide 500*275(mm) for 52CM and 730*275(mm) for model 75CM. Pic 1. Make sure the hole edge to the cupboard edge at least 35mm distance.
-
Page 8: Light Replacement
2. LIGHT REPLACEMENT (1) Unscrew the 4 screws on the outer glass frame panel by screwdriver (2) Pull out the light wire, and take down the outer glass frame panel (3) Unscrew the screws on the light bracket and replace the light (4) Connect the light wire and assemble the outer glass frame panel by screw. - Page 9 (Timer), (Lamp), (Speed) (Power). See Pic 1. Power on: After you have connected the cooker hood to the main supply, the backlight of button will turn on. The backlight will turn off after 30s without any operation and the cooker hood will enter into stand-by mode. 2.
-
Page 10: Maintenance
4. MAINTENANCE 1) The cooker hood and its filter mesh should be cleaned regularly in order to keep in good working order. Because the grease filters are made of metal, do not clean the filters with detergents that will corrode metal products. Clean the filters as below: a) Method one: Put the filter in the water(40℃-50℃), pour in some grease-loosening detergent,... -
Page 11: Abnormity And Solution
Keep your children from using the cooker hood. Your cooker hood is for domestic use only, not suitable for barbecue, roast shop and other commercial use. Any installation work must be carried out by a qualified electrician or competent person. - Page 12 Combination screw loosen Screw it tight Body hang unfixable Tight the body The distance between the body and Readjust the distance the gas top too long Cross-ventilation too strong or too Reduce cross-ventilation closed in the kitchen or open the window Exhaust pipe too long Adjust the length of pipe Insufficient suction...
Need help?
Do you have a question about the FAL-52-BIS and is the answer not in the manual?
Questions and answers